Please note: Due to the nature of wood and wood laminate, each Lamo Camo grip is unique in figure and color. The pictures above may not represent the grips that are in current inventory.
Will fit models 85, 856, 94, 327, 380, 605, 650, 651, 850, 851, 905, 941 and 942.
Will NOT fit models 445, 606 or polymer frames.
Newest models have a new grip from Taurus. This grip uses a pin through the grip to secure the grip to the frame. To change the grip, the pin must be driven out. Replace with the pin included with the grip. Please review the instructions included with your grip.
Please note: If your frame pin is 1/2" across or less, you do not need to change it out for the included pin.
Fits the following Models:
380 /605 / 85 / 856 / 905 / 942 / 327
NOT :
Polymer Models
- Model:
- Taurus 327
- Model:
- Taurus 380
- Model:
- Taurus 605
- Model:
- Taurus 856
- Model:
- Taurus 905
- Model:
- Taurus 942
-
-
-
-
Out of stock
Reviews
-
Great for belt holster
Grips fit good only had a small spot that i sanded smoot with some 1200 grit. Only issue i have with them is they are longer than expected. It dors allow for 3 finger full contact but i pocket carry my 856 100 percent and its a little too long for that. Other than that they look great and feel great. Would recommend as long as your not carrying in the pocket.
-
Hogue Lamo Camo
This is an excellently crafted grip and it is truly built to match the natural grip of the hand. One thing to consider, this grip adds considerable length to the bottom of the frame and can be a hindrance if your intention is concealment. While I did return this grip for that reason, I fully intend to purchase this same item sized for my 627 Tracker.
-
Hogue Lamo Camo Grips w/ finger grooves
Very well made and fit my revolver perfectly
-
HOGUE SMALL FRAME LAMO CAMO GRIP W/ FINGER GROOVES
This a Nice look and feel for my Taurus 856UL Two tone model. Take your time installing it. It will install on an included stirrup. And new screw from the bottom of grip. I had to sand the grip along the backstrap, for a proper fit. This is normal. After sanding and multiple pre fits, just polish with a quality wood polish/oil. I do not recommend any polyurethane. It will chip and scratch. Please realize your backstrap will be exposed with this grip. Took me approx. an hour to install and a fun little project. It looks really great! I have already gotten, "That's a really nice little gun." comments. I am very pleased.